Phone:

033 4006 8914

Our Authorised Dealers

 

   
MISTOMETER - Wood Moisture Meters  
   
Mistometer QX  
Technical Specifications  
   
Display :

Liquid Crystal Display (LCD).

Moisture: :

Two decimal digits in the large Data Window

Low Battery :

BAT is displayed in the small Status Window when the Battery voltage drops below usable levels. Please note that, with too low a Battery voltage, even this indication might fail. For accurate readings, Battery should definitely be changed as soon as this indication comes on.

Over-range: :

A sign looking like▲is displayed in the small Status Window when the moisture reading is more than 25%. During over-range, though a reading will be displayed, the accuracy is not guaranteed.

Under-range : Below a moisture reading of 6%, the meter will display 00.
     
Range : 6 to25%.
Probes : 6.5 mm stainless steel pointed probes.
Dimension : l5l mm x 79mm x 22mm.
Weight  : 180 gms. (with battery).
Power : l x 9 Volt 6F22 or equivalent Battery.
     

   
Operation  

Remove the front cover and fit it at the other end and then push the METER gently against the sample so that the pins enter 2 to 3 mm into the sample and press with thumb as shown to get the reading.

 

     

   
Mistometer Slim 7  
Technical Specifications  
Display : Light Emitting Diodes (LEDs).
Moisture: :

Any ONE of the moisture readout LEDs will glow to show the moisture percentage. If TWO LEDs are glowing, then, the actual value is somewhere between them.

Low Battery :

When the Battery voltage drops below usable levels, the LED marked as BAT will come on. Please note that, with too low a Battery voltage, even this indication might fail. For accurate readings, Battery should definitely be changed as soon as this indication comes on.

Over-range: : When the moisture reading is more than 23%, the LEDs corresponding to 6% and 23% will both come on.
Under-range : Below a moisture reading of 6%, the meter will display 6%.
     
Range : 6to23%.
Probes : 6.5mm stainless steel pointed probes.
Dimension : l47mmx 65mm x 24mm.
Weight  : 180 gms. (with battery).
Power : 1 x 9 Volt 6F22 or equivalent Battery.
     

Operation  

Remove the front cover and fit it at the other end and then push the METER gently against the sample so that the pins enter 2 to 3 mm into the sample. This will automatically turn on the Meter and the LED corresponding to the moisture % will glow.